Operation Manual
Wheels, tyres, brakes
It is in your own interest to have the brakes checked
regularly by your Fiat or Iveco workshop.
04-8
For further information, please refer to the Fiat Ducato or
Iveco Daily operating instructions.
• Remove the wheel mounting screws and lift off the tire.
• Place the spare tire on the wheel hub and align it.
• Screw the bolts on and tighten them in a diagonal sequence.
• Lower the car jack and remove it.
• Tighten the wheel mounting screws evenly with the wheel
spanner. Please refer to the operating instructions for
the base vehicle for the specied value of the tightening
torque of the wheel mounting screws.
• Place the tire you have removed in the (possibly existing)
spare tire holder and then shut the holder.
4.8 Brakes
The components in the brake system are part of the General
Type Approval (“Allgemeinen Betriebserlaubnis“, ABE).
If you change the components in the brake system, the type
approval expires. Any changes are only possible if they have
been released by the manufacturer.
The following applies when maintaining the brake system:
• Check the level of brake uid regularly.
• Check the brake system and brake hoses regularly for lea-
kage. Martens often gnaw at rubber hoses.
• Use only brake uids with the same qualities as those
uids already in the brake circuit.