Operation Manual
Built-in devices
10-7
Use the adjusting knob / pushbutton to select the icon in the
menu line
m
.
- Press to switch to the setting mode.
Setting the timer
- Use the adjusting knob / pushbut-
ton to set the hours and then the
minutes.
Entering the start time
- Use the adjusting knob / pushbut-
ton to set the hours and then the
minutes.
Entering the end time
The timer can only be selected if the clock on the control panel
has been set.
If the timer has been activated (ON), the menu item Activate timer
(OFF) is rst displayed.
As soon as the heating has been switched on (room tempe-
rature and hot water temperature have been activated) the
fan speed selected in the previous heating operation is
displayed in the status line. Manufacturer's default setting:
“ECO”.
1)
Can lead to higher engine wear, depending on how often it
is selected.
2)
The “HIGH” fan speed has a higher current consumption,
higher noise level and higher engine wear.
d
BOOST To heat room rapidly
Available if the dierence between the
selected and the actual room tempera-
ture is more than 10°C.