User Manual

Towerpro Mag 8 Brushless Motor
Speed Controller Manual
Operation Limit:
12A: max current 15A, continuous current 12A for 10 minutes
25A: max current 30A, continuous current 25A for 10 minutes
30A: max current 35A, continuous current 30A for 10 minutes
Voltage Range: 6V-12V
Number of Batteries: 4-12NiMH, 2-3LiPo
BEC Output: 5V1.5A.2LiPo\4-5mini servo, 3Lipo\3-4mini servo
Protective Functions:
Automatically select 2◆ -3LiPo,protective voltages are 6V/9V respectively;
Automatically select NiMH, the protective volta◆ ge for each battery is 0.8V.
Safe start ◆ –will not start if the throttle stick is not in the right position;
Temperature protection, shutdown if the surface temperature reaches 110 ◆℃
lost of control protection, shutdown after I second without signal◆ .
Performance:
motor limit: ◆
2☆ -pole adversion as high as 300000rpm
12☆ -pole adversion 50000rpm
14☆ -pole adversion 42000rpm
For 8KHzpWM control , ◆
Position of the full, throttle will be adjust automatically ◆
BEC and MCU use separate power s◆ upply for table operation.
Setting Method:
1. Open the transmitter, switch throttle stick to the full power position (for FUTABA series
transmitter, the throttle stick shall be switched to REV).
2. Connect the receiver and motor.
3. Connect the power to the speed controller.
4． If the transmitter is in normal condition, it will have the following sound: (if there are no more
sounds after a long low sound at the end of this sound, check the reverse setting of the
transmitter throttle channel).
B: ☆ indicates LIPO automatic protection
BB BB: indicates NiMH/NiCD automatic protection ☆
BBB BBB: indicates brake selection ☆
5. If there is setting you want in the process of sound cycle, switch the throttle
stick, to the lowest position at the first time interval. (For example, select
LIPO automatic protection: switch the throttle stick to the lowest position when
hearing one B sound)
6. If there is another additional setting, quickly switch the gun to the highest position to make a
selection.