X-car Beast 1/8 120A manual

identify the motor type (Sensored/Sensorless) via LED lights

* If the ESC works in Sensored Mode, remove the Sensor wire and the ESC will automatically

change to Sensorless Mode.

Function

LED

LED Status

Low voltage of the battery

Over-heat of the ESC and motor(95℃)

Sensored motor

Sensorless motor

Red LED

Blue LED

Red and Blue LED

Blue LED

Blinking

Throttle Range Calibration

1. Turn on the transmitter, then connect ESC with the battery packs and set the direction of the

throttle channel to REV; set the EPA/ATV value of the throttle channel to 100%.

2. Press and hold the “Set” button and switch on the ESC, release the button when the Blue LED

turn solid. Pull the throttle trigger to full position, Red LED light will flashes and motor beeps

once. when system confirms the position.

3. Push the throttle trigger to full Brake position, Blue LED light will flashes and motor beeps

twice when system confirms the position.