User Manual

第 - 3 - 页 共 7 页
：If losing the signal of receiver during the operation, the output of motor will be cut off in 1S and makes sound of
BEEP “∮__”with interval 1S.
( but PCM receiver lose the signal of transmitter , it will keep the normal control signal, ESC won’t provide the
sound through motor at this time.)
※ For gun-type remote control and panel-type remote control , ESC support the set of half throttle trip .It can set the
Maximum –Minimum. The maximum – every position where between middle throttle and the Max position.(when
using the panel remote control without being back to the middle automatical ,the residence time of the maximum
throttle setting should wait for the end of the sound of battery test. For security, if the throttle is pushed when the
throttle is lower the middle the throttle, the present position should be as the lowest position. Please pay attention to
it.)
III. Start up
》a Push the throttle to the lowest ( two-way throttle back to the middle)
If ESC has connected in circuit, please check if ESC connects battery pack. If connected battery pack, please
disconnect the battery pack.
》b Connect ESC with battery pack.
》 c Wait for 2S, motor will make the N times sound of BEEP “∮__”(N=LiPo cells),( “__”means pause a while after
the sound ∮.
Shows the power supply voltage of ESC is in the appropriate range. If there is no sound, shows
the voltage of ESC’s battery pack isn’t in the specified range. For example, ESC’s voltage is 2-6S, if it’s lower than
2S or higher than 6S, ESC won’t make sound.
》d “N”times sound , motor will make continuous 2 short sound ∮∮
ESC enter the process of remote control throttle trip automatic practice. It can operate with starting by controller.
Ⅳ. Set the alteration of main options
》1 When starting with factory default parameter, it won’t enter “4 set alteration of main options”.
》2 The processing of altering ESC’s parameter is as following:
》3 If ESC has connected in the circuit, please check if ESC has connected battery pack.
If connected battery pack, please disconnect battery pack first.
》4 Push the throttle of remote control to the Max position in the forward direction and keep in this position. Connect
the disconnected battery pack in the circuit again , wait for 2S.
*1 Motor makes the sound of BEEP“∮∮__∮∮__∮∮__”
*2 Motor makes the sound of BEEP“∮↑∮↓__∮↑∮↓__∮↑∮↓__”
Enter main options 1～6
BEEP“∮__∮__∮__”3 times，main option 1
BEEP“∮∮__∮∮__∮∮__” 3 times，main option 2
BEEP“∮∮∮__∮∮∮__∮∮∮__” 3 times，main option 3
BEEP“∮∮∮∮__∮∮∮∮__∮∮∮∮__” 3 times，main option 4
BEEP“∮∮∮∮∮__∮∮∮∮∮__∮∮∮∮∮__” 3 times，main option 5
BEEP“∮↑__∮↑__∮↑__” 3 times，main option 6
*3 When you hear the sound of the main option that you want to set, please loose the throttle to the middle, enter “the
sub option of this main option”.
*4 “ prompt tone chart”, every sub option makes 3 sounds as the order in the chart. Don’t move the throttle, it will
make sound in the 3 sub options circularly. When hearing the sound that you wanted sub option . Push the throttle to