User Manual

5） Customized ESC can be made acc ording to custom ers ’ requirements.
II.
II.
II.
II. The
The
The
The i ntroduction
introduction
introduction
introduction of
of
of
of the
the
the
the connection
connection
connection
connection in
in
in
in the
the
the
the ESC
ESC
ESC
ESC
In order to avoid short circuit and leakage, the joint are connected by thermal shrinkable pipe to ensure
insulation.
Battery Pack Black Red White Motor
III.
III.
III.
III. The
The
The
The function
function
function
function of
of
of
of electric
electric
electric
electric speed
speed
speed
speed controller
controller
controller
controller for
for
for
for brushless
bru
shless
brushless
brushless motor
motor
motor
motor
1. Reset to factory default
2. Battery types set(Lipo or NiMh/NiCd)
3. Brake set (yes/no)
4. Threshold set of protection for low voltage (set a protective value for low voltage)
5. Motor entrance angle set (improve the service efficiency of ESC and the stability in the starting)
6. Accelerated startup set (used in precise gear box and application of helicopter)
7. Helicopter mode (used in application of helicopter)
8. Steering motor (clockwise/anticlockwise)
9. Operating frequency set
10. Protection mode under low voltage (reduces power or halts immediately)
VI.
VI.
VI.
VI.
The
The
The
The operation
operation
operation
operation steps
steps
steps
steps of
of
of
of programming
programming
programming
programming in
in
in
in ESC
ESC
ESC
ESC for
for
for
for brushless
brushless
brushless
brushless motor.
motor.
motor.
motor.
Push the pull rod of throttle in the ESC to the highest position to make the ESC enter the setting m ode and
then turn on the ESC.
Remark: the ESC enters the setting m ode when the pull rod of throttle in the ESC is pushed to the highest
position; the ESC enters the working mode when the pul l rod of throttle in the ESC is pushed to the lowest
position.
1) Connect the battery pack to the
ESC. After two seconds, a beep shows that the ESC enters the setting mode.
The menu of setting mode is a cycle model. Each function corresponds to one corresponding musical tone.
Each musical tone will ring out for four times continuously. During the four periods when music rings, push the
pull rod of throttle in the ESC to the lowest position. Then the motor will give out a beep to inform that
corresponding parameters have been stored, and the ESC enters the working mode.