User Manual

ManualsBrandsHobbyKing ManualsHobbyGas Engine CDI Ignition Test and Timing Setup Tool - Includes Crankshaft Degree Wheel

Multifuncţional CDI

Testing

Tools

There

are two function in this products

Function

: Test

CDI

Ignition

working condition and testing kit for

gas/petrol engines.

without

the

need

to start the

engine.Analog

engine

speed

in between the

400RPM-18000RPM

,can be used to check radio interferences,and the radio range

check

full

instructions supplied.

Function

2: Hali

sensor

test kit and timing test kit

Our

ignitions are supplied as standard equipment on many

engines and any repairs

or modifications may require the static timing point to be reset or

checked.The

kit will

aliow you to check and set your static timing point as specifiedjt comes

with

LED

SHOW

and audible (Buzzer) signals.The ignition when checking over the magnet in the

trigger point. Is to stop the light-emitting

LED

and audible

buzzer

to stop the moment

when the ignition spark.This kit can also be

used

to check the correct operation of the

hali

sensor

and

determine correct magnet orientation.

Function

1 Test Way .

Use

4.8-6Volt battery in biack and red power line

Connect

the needie of test kit

with

the biack ,red and white line.

11 AUTOMAT!? AOVANCING

ANGIEIGNITION

FOR GAS ENOIH£

Use 4.8-6V

battery

j WL

ELECTRONIC

IGNITION

Insert

CDI

test

kit

3, Pay

attention to the connect direction the white line connect to the "out" mark of

the

test kit

white line

Summary of content (2 pages)

PAGE 1
Multifuncţional CDI Testing Tools There are two function in this products Function 1 : Test CDI Ignition working condition and testing kit for RC gas/petrol engines. without the need to start the engine.Analog engine speed in between the 400RPM-18000RPM ,can be used to check radio interferences,and the radio range check full instructions supplied.
PAGE 2
4, When plug in the CDI Ignition, there wili be spark in spark cap ,then the led light-emit in the test kit Turn the test kit clockwise (Analog engine speed in between the 400rpm-18000rpm) FUNCTION 2 TEST WAY: 1 Connect the biack red line with DC 4.8V-24V battery , connect the biack ,red and white line of test kit with the matched line of hali sensor 2, Turn the prop hub during operation, when the magnet near the hali sensor, the LED light-emit and audible (buzzer) signals in the test kit.