User Manual

THIS THING IS TINY!!! I used this soldering station, available from the Hobbyking USA warehouse
http://www.hobbyking.com/hobbyking/store/__19240__Soldering_Station_with_Adjustable_Heat_Range_USA_W
arehouse_.html
It has a very precise tip, and works excellent for small circuit board jobs like this. Get one when you order your
servos, you will find lots of uses for it.
While soldering, be very careful not to “smear” solder across all the contacts and short them out. I used NO extra
solder for any of this mod…the existing solder on the wires and on the solder pads is more than enough. Just melt
it, remove the wires, melt it again and reattach the wires.
Figure 3: Hold the circuit board as shown. You will need to swap the middle wire with the left wire.