No File Name

MODELS:FS-GT2
8
Digital propotional radio control system
Http://www.flysky-cn.com
9.2.4G Operation notes
Match line
对码线
Figure 1
Bind key
9.01 Matching (code)
A.
Install the battery to 2.4G transmitter and shut it down.
B. / (Insert the matching lines to the channel BIND CH3 port of the receiver. Figure.
C.Connect the receiver battery to VCC port of the receiver, on the same time the two LED are flashing
D.Press and hold the button on the transmitter, and then switch on the power supply.
F.Release the match button on the transmitter, take out the match line.
E. Observe the LED on the receiver, if find that the LED is not flash anymore and that means successful
G.Install the server and then test.
H.If the tests fail, please repeat the action above.
I.If the tests success, then insert the power supply port into VCC, match complete.
(The above ways of match is only suitable for FLYSKY 2.4G products)
Our products are well matched in the factory, you do not need to match by yourself. But if your
are going to match the receiver with other transmitter, or you need to change a new receiver
or transmitter, please follow the following steps:
and this means the receiver are going to the matching status.
Matched. This process about 5s
（ )
我们的产品在出厂前已经过配对，您无需做配对动作便可使用。但如果您要将接收机跟另外
的发射机进行配对使用，或者您要更换新的接收机或者发射机，请您按如下的步聚进行：
注:我们的接收发射系统,不跟其它品牌兼容!
3.将接收机电池插入接收机的VCC通道接口,此时可看到接收机的LED在闪烁,此表示接收机进入配
5.观察接收机上的LED,如果发现LED不再闪烁表示配对成功.(注:此过程大约时间为5S左右）.
1.将2.4G发射机装好电池，并关闭发射机。
2.将配对线插入接收机的BIND/CH3通道接口（如图1）.
4.将发射机上的配对键(BIND)按住，然后打开发射机电源开关。（注：不要松开按键）。
6.松开发射机上的配对按键,拔掉接收机上的配对线.
7.将伺服器装上并通电测试.
8.如果测试NG,则重复以上动作.
9.如果测试OK，则将电源接头插入VCC，配对完成。
注:以上配对方法,仅适合于FLYSKY的2.4G产品。
对状态.
LED
Battery
电池
Receiver
接收
对码按钮
(图1)