User Manual

Speed Controller Programming Instructions
For Helicopter ESCs H20A/H30A/H50A
H20A/H30A/H50A Parameters:
ESC for
ESC for ESC for
ESC for
Helicoptor
HelicoptorHelicoptor
Helicoptor
Cons
ConsCons
Cons
-
--
-
Current
CurrentCurrent
Current
Max
Current
BEC
Input
TIMING
PWM
Governor
mode
Cut
CutCut
Cut-
--
-off
offoff
off
Voltage
VoltageVoltage
Voltage
Weight
WeightWeight
Weight
H20A 20A 30A 5V 3A 2-3 Lipo 0 8k Programmable
25g
H30A 30A 40A 5V 3A 2-3 LiPo 0 8k Programmable
28g
H50A 50A 65A 5V 3A 2-4 LiPo 0 8K Programmable
Lipo mode:
2.8V per
cell
50g
Other features:
* Lipo cells auto-detect
*Soft star
* Governor mode programmable (4 options: Disable, 2-4 poles, 6-10 poles, 12-14 poles motor)
* ESC slow down at 3V per cell lipo and Cut –off voltage at 2.8V per cell
Programming Instructions:
1. Connect your motor and receiver to the speed controller, but do not connect the battery yet.
2. Turn on your transmitter and full up the throttle stick. Please Note: Most Futaba transmitters
have the throttle channel reversed by default.
3. Connect your battery and you will hear a starting beep tone. After 3 seconds, the controller will
start beeping a sequence as following. All beeps only repeat once.
4. To select, move the throttle stick in off position, between Beeps repeat. Then you will hear a
confirmation sound.
5. Each time when you select an option, it will exit programming menu and is ready to use. To
choose another option, you need restart from step 1.