User Manual

10A/20A/30A/40A/BEC50A /

• How to enter the option set mode:

Beep Sound Beep sound's Meaning

one short high tone beep

two short high tone beeps main option II: Li-Po battery

---

three short tone beeps

The protection Voltage of LI-PO battery is 3.0V per cell, number of cells automatically detected.

Table 1.2 (MENU description for H30A/H40A helicopter low-voltage ESC)

Beep Sound Beep Sound's Meaning

ESC manual setting options (including E-Helicoter version)

1 Connect Motor and ESC and Receiver, but be careful not to connect the battery and the

ESC's power cables.

2 Switch on transmitter, and have the throttle to the highest position (full throttle). (Note:

most of Futaba transmitter's throttle position is reversed.)

3 Connect ESC and battery power cable, ESC will control the motor to sound with some

rhythm beep sounds.

• How to sdtting option:

After entering option mode, the motor will sound some regular tweet sounds: one or more

short sounds (depending on different specifications, see Table 1.1 and Table 1.2). These

sounds are the current options of the ESC program tone, each tone will be repeated three

times, after that, will change to the next option, the sound can be set before the end of the

command input. Menu option is cyclic, if missed, could once again reach such a tone, it just

takes some time. Options beep meanings as follows:

When the option alert tones appears, because it is 3 cycles, it is recommended you watch

the first time, when heard the second voice, confirm and opperate setting at once. Pull stick

in the end of throttle (off throttle) position, the motor will emit a long high-tweet to confirm

the current options and save data and exit setup status. As the throttle in the closed

position, a prompt beep sound (see Table 2.1 and Table 2.2) will be followed by ESC

restarts and enters ready to start the motor..

Table 1.1 (MENU description for 10A/20A/30A/40A/BEC50A boat/ aircraft low voltage

ESC)

main option I: NiMH battery*

main option III: Brak setting**

The auto cutoff voltage of NiMH battery is to take power voltage's 60%.

PAGE 1
ESC manual setting options (including E-Helicoter version) 10A/20A/30A/40A/BEC50A / • How to enter the option set mode: 1 Connect Motor and ESC and Receiver, but be careful not to connect the battery and the ESC's power cables. 2 Switch on transmitter, and have the throttle to the highest position (full throttle). (Note: most of Futaba transmitter's throttle position is reversed.) 3 Connect ESC and battery power cable, ESC will control the motor to sound with some rhythm beep sounds.
PAGE 2
- one short high tone beep main option I: for no constant speed normal mode -- two short high tone beeps main option II: for 2-4 poles motor's constant speed ( random +/- speed)* mode --- three short tone beeps ---- four short tone beeps main option III: for 6-10 poles motor's constant speed mode main option IV: for 12-14 poles motor's constant speed mode (Helicopter ESC only supports Li-Po battery, and is 2 or 3 cells auto detection, so the only constant mode in the options menu, the other extra