User Manual

Features
•
Loud >85dB alarm gets your attention
•
Two alarm tones pattern
•
Works with AM/FM PPM or FM/PCM R/C systems
•
Plugs into any standard servo channel
•
Small dimensions and weight
Specifications
Model Size Weight
Operating Voltage
(mm)
(g) (V)
SU/LMA 17x13x10
4.S(with wire)
4-6
Installation and Use
RECEIVER Channel X ... ii---
~
Current Drain
(mA)
1-35
(./)
c
-
r
~
)>
.
1) Connect the LMA to RC equipment. Turn on your transmitter, then your receiver. You will hear 2 x beep.
2) Do not move the stick
on the transmitter or turn off the transmitter. After one minute you will hear hurried
beep (pattarn 1) that repeats as long
as to move the stick or turn on the transmitter in the next minute.
3) If you could not stop the beep
in the next minute then a very distinct beep-warble-beep(pattarn2)was
performed continuously.
4) At this time, you can but disconnect the LMA from the receiver to stop the alarm.
NOTICE
• Always be sure to observe the proper polarity on the connector pins and receiver sockets.