User Manual

9
EN DE FR IT
When the elevator stick is moved backward, the elevator should move up. This
will cause the nose of the ariplane to lift in flight.
Move the rudder stick left and right to check turn control. When the stick is
pushed to the right, the rudder should also move to the right.
With the rudder stick pushed to the left, the rudder should move to the left.
If at any time during the test the controls respond in the opposite direction,
reverse/change the direction of operation of the flight controls. To do this, consult
the Reversing Flight Controls section.
After reconfirming the flight control directions, all controls should
function properly.
Digital Trims
The HobbyZone 2.4GHz DSM2/DSMX transmitter features digital trim buttons next
to the control sticks to make fine adjustments. Use these to center the control
surfaces. If there is not enough digital trim available, mechanically adjust the
loops in the control linkages to center the surfaces.
Transmitter Binding Instructions
In the event you need to re-bind your transmitter to your airplane, follow the steps
below.
1. Plug battery into airplane with the transmitter turned off.
2. When you see the LED on the receiver begin to flash while looking through
the opening at the back of the battery cavity of the Champ, push the left
stick of the transmitter inward into the case (NOT pulling down on throttle
stick) until you hear it click.