User Manual

Apprentice
®
S 2 1.2m
EN
9
Wing Installation
1. Connect the aileron servo connectors to the included Y-harness (A) in the
fuselage. The left and right servos can be connected to either side of the
Y-harness. Ensure the Y-harness is connected to port 2 of the receiver.
2. Install the wing on the fuselage.
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
3. Install 6 rubber bands (B) on the front and back rods to complete the
installation.
Disassemble in reverse order.
IMPORTANT: Correct operation of the SAFE system requires connection of
both ailerons to the included Y-harness and port 2 of the receiver.
OR
1
2
B
A
Control Horn and Servo Arm Settings
NOTICE: Moving a linkage to another position may block the servo arm or
affect SAFE technology functionality.
The Illustration shows the factory hole settings in servo arms and control horns.
Elevator Ailerons Rudder
ArmsHorns
Nose Gear
Rudder