Carbon Cub S+ 1.3m Action Card

Carbon Cub S
+
1.3M Action Card
Flight Modes
Virtual Fence Selection (Mode 2 transmitter shown)
Compass Calibration
Deactivating GPS
Flight Mode TX Switch Position
Beginner FM 0
Intermediate FM 1
Advanced FM 2
Holding Pattern* Press and release HP/AL(Bind)
AutoLand*
Press and hold (3seconds)
HP/AL (Bind)
* Changing the flight mode switch or pressing the HP/AL (bind)
button will interrupt Holding Pattern or AutoLand Modes.
Hold the transmitter sticks as shown while the aircraft GPS
system is initializing to change the active Virtual Fence Mode.
Virtual Fence OFF
•Low throttle
•Full right aileron
•Full up elevator
Circle Virtual Fence, Small (Default)
150m radius from home location
•Low throttle
•Full left aileron
•Full up elevator
Circle Virtual Fence, Large
250m radius from home location
•Low throttle
•Full left aileron
•Full down elevator
Airfield Virtual Fence*
400m long x 200m wide flight area with
no fly zone set 4m from the home location
•Low throttle
•Full right aileron
•Full down elevator
* Airfield Virtual Fence requires the additional selection of a flying
area direction based on the specified home location.
Compass calibration should be performed before the first flight
and whenever the aircraft is flown at a new location. Refer to the
product manual for complete compass calibration instructions.
Push and hold the HP/AL (bind) button and fully cycle the flight
mode switch 3 times. Power cycle the aircraft to re-activate.