User Manual

Carbon Cub S2
®
EN
10
A
B
D
E
G
H
3 X 12mm (4)
2.5 X 10mm (6)
I
C
F
R-AIL
L-AIL
Install the Wing
Assembly
1. Install the vortex generators (A) in the wing channels
(B) by using double-sided tape (C).
2. Slide the wing tube (D) in the hole in the left wing.
3. Slide the other end of the wing tube into the hole in the
right wing until both wings meet.
4. Install the wing cover (E) on the top of the wing, aligning
the 4 holes as shown.
Installation
NOTICE: DO NOT crush or otherwise damage the wiring
when attaching the wing to the fuselage.
1. Connect the left aileron servo connector to the servo
extension labeled “AIL-L”, and connect the right aileron
servo connecter to the servo extension labeled “AIL-R”.
2. Attach the assembled wing and wing cover (E) to the
fuselage using 4 screws (F).
3. Attach the right (G) and left (H) struts (marked R and L)
under the wing and fuselage using 6 screws (I). Adjust
the position of the 4 screws in the top of the strut slots
so the wings are not exed down or twisted.
Disassemble in reverse order.