User Manual

Carbon Cub S2
®
EN
4

1. Remove and inspect contents.
2. Read this instruction manual thoroughly.
3. Charge the ight battery.
4. Fully assemble the aircraft
5. Make sure all linkages move freely.
6. Install a fully charged ight battery in the aircraft.
7. Check the Center of Gravity (CG).
8. Set up your transmitter (BNF only)
9. Bind the aircraft to your transmitter (BNF only)
10. Place the aircraft into Experienced Mode (Mode switch position 2) for the Control Direction Test.
Place the aircraft on the ground facing away from you.
11. Perform the control direction test with the transmitter
12. Adjust the ight controls and transmitter as needed.
13. Place the aircraft into Beginner Mode (Mode switch position 0) for the SAFE Control Direction Test and takeoff.
14. Perform SAFE Control Direction Test
15. Find a safe open area to y.
16. Perform a radio system range test.
17. Plan ight for ying eld conditions.
18. Set ight time for 8 minutes.
Optional Upgrades (not included)
Landing Assist Sensor (LAS) GPS Module
When added, the LAS module will work hand-in-hand with the AutoLand
feature for a picture perfect landing every time. When the aircraft is on
approach and approximately 1m from the ground, the LAS module will level
out the aircraft, adjust throttle if needed, and then are the aircraft just
before touchdown.
When added, advanced SAFE+ features can keep the aircraft within a given
distance to the pilot (Virtual Fence), can return the model to home at the press of
a button (Holding Pattern), can return home automatically if the controller signal
is lost (Failsafe), and can land itself when commanded (AutoLand).
From the Box to the Air (No LAS or GPS Module)