Carbon Cub S 2 1.3m Manual

RTF/BNF Basic

Carbon Cub S2

WARNING: Do not perform this or any other

equipment test with the propeller installed on the

aircraft. Serious injury or property damage could result

from the motor starting inadvertently.

If performing the control direction test indoors, disable

GPS as shown in Deactivating GPS before performing the

control direction test.

Set the SAFE ight mode switch to Experienced mode

(position 2).

Keep the throttle at zero and place the model on level

ground away from obstacles.

Move the sticks on the transmitter as described in the

table to ensure the aircraft control surfaces respond as

shown.

If the control surfaces do not respond as shown, DO NOT

FLY. Refer to the Troubleshooting Guide for more informa-

tion. If you need more assistance, contact the appropriate

Horizon Hobby Product Support department.

If the aircraft responds as shown, continue on to the Flight

Control section.

Control Direction Test

Transmitter command Control Surface Response

ElevatorAileronRudder