Carbon Cub S 2 1.3m Manual

Carbon Cub S2
®
EN
6
Elevator/Aileron
Stick
Throttle/Rudder
Throttle Trim
Bind/HP*/AL*
Button
SAFE Plus Mode
Switch
Power Switch
Elevator Trim
Mode 2 shown
Rudder Trim
Hi / Low Rate
Switch
Throttle Cut
Switch
A
B
C
E
D
Aileron Trim
Flight Battery
Voltage Indicator
Installing the Transmitter Batteries
Remove the battery cover, install the four included batteries
(noting proper polarity) and reinstall the battery cover.
Low Battery Alarm
The LED indicator ashes and the transmitter beeps pro-
gressively faster as the battery voltage drops.Replace the
transmitter batteries when the transmitter begins to beep.
CAUTION: If using rechargeable batteries, charge
only rechargeable batteries. Charging non-
rechargeable batteries may cause the batteries to burst,
resulting in injury to persons and/or damage to property.
WARNING: Do not pick up the transmitter by
the antenna. Do not alter or put weight on the
antenna. Damage to antenna parts can decrease trans-
mitter signal strength, which can result in loss of model
control, injury or property damage.
For complete transmitter instructions and features, visit
horizonhobby.com.
Transmitter
*(HP)= Holding Pattern
*(AL) = AutoLand
WARNING: Before proceeding further, remove the propeller and spinner from the motor shaft. Never at-
tempt to program the radio components, assemble the aircraft or perform maintenance of any kind without
removing the propeller. Serious injury could result if the motor starts inadvertently with the propeller still attached.
1. Remove the M2.5 X 8 mm screw (A)
and spinner (B).
2. Use an adjustable wrench to remove the
hex nut (C), propeller (D) and spinner
backplate (E).
Battery Voltage Level
The included DXS transmitter includes a new ight battery
voltage level indicator feature.
LED SMART Battery voltage indication is based on current
voltage and will change with throttle/power usage. When
throttle is increased, voltage drops, causing the bars to
indicate lower power (e.g., fewer LEDs solid or ashing.)
When the throttle is lowered to idle/off, the bars recover
(e.g., more LEDs solid or ashing). LED bars will rise and
lower depending on throttle/power usage.
The SMART Battery low voltage alarm sounds when the
ESCs are close to reaching low voltage cutoff. The alarm
will sound for 25 seconds. If the throttle is lowered to allow
voltage recovery, the alarm will stop early.
Land the aircraft when the alarm sounds.
After landing, reset the SMART Battery low voltage warning
by either (1) powering cycling the DXS transmitter, or (2)
disconnecting the battery from the aircraft for more than
15 seconds or until the LED voltage indication bars go out.
Connect a fully charged battery to the aircraft, which will
ensure the SMART Battery low voltage warning resets prior
to the next ight.