Carbon Cub S 2 1.3m Manual

RTF/BNF Basic

Carbon Cub S2

3 X 14mm (2)

2 X 8mm

Install the Tail

1. Install the horizontal tail (A) on the fuselage as shown.

2. Carefully insert the 2 pins of the vertical n (B) through

the horizontal tail holes and the fuselage holes. Turn the

rudder so the control horn is under the horizontal tail.

3. Under the fuselage, install the 2 screws (C) into the

fuselage and the vertical n pins. Tighten the screws,

but do not break the plastic.

4. Install the rudder hinge screw (D) as shown. Tighten the

screw, then loosen it one half of a turn so the rudder

turns freely.

5. Connect the respective clevises in the outermost holes

in the rudder and elevator control horns. Refer to the

clevis adjustment instructions to center the rudder and

elevators.

Disassemble in reverse order.

Adjusting the Clevis at the Control Horn

After binding the transmitter to the aircraft receiver, center

the trims and set the sub-trims to 0 (if applicable), then

adjust the clevises to center the control surfaces.

Turn the clevis on the linkage to change the length of the

linkage between the servo arm and the control horn.

1. Pull the tube from the clevis to the linkage.

2. Carefully spread the clevis and insert the clevis pin into

the desired hole in the control horn.

3. Close the open clevis side over the pin.

4. Move the tube to hold the clevis on the control horn.

Ensure the tube does not interfere with the movement

of the control horn anywhere throughout the control

surface range of motion.