User Manual

RTF/BNF Basic
Carbon Cub S2
EN
29
Holding Pattern Mode
Holding Pattern Mode,
Aireld Virtual Fence Active
Holding Pattern (HP) Mode
If at anytime the aircraft seems too far away, press and release the HP/AL
(bind) button on the transmitter.
The aircraft will maneuver to an altitude of approximately 120 feet (36m)
and begin to y a circular pattern over the home location.
If Aireld Virtual Fence mode is active, the aircraft will y to approximately
120 ft (36m) altitude and y a circular pattern about 100 ft (30m) in front of
the home location.
The aircraft ies fully autonomously when HP mode is active. The
transmitter sticks have no control.
NOTICE: As a safety precaution, Holding Pattern mode will not function
when your aircraft is below an altitude of approximately 20 ft (6m).
To deactivate HP mode and regain control, press and release the HP/AL
button again or change ight modes.
IMPORTANT: When the HP feature is activated, the aircraft should
immediately respond to the command. If the aircraft does not respond
immediately, GPS signal may have been lost. In this case, the aircraft will
have to be own back to the home location manually.
Failsafe (LED: RED SLOW FLASHING)
If at anytime the aircraft loses radio connection, the aircraft will activate
Holding Pattern mode until it re-establishes radio connection. If radio
connection is not regained, the aircraft will land near the takeoff location as
in AutoLand mode.
If radio connection is lost while the aircraft is already in Holding Pattern
Mode, the aircraft will circle for approximately 35seconds and then set up
to land as in AutoLand mode.
NOTICE: If a crash is imminent, activate throttle hold or quickly lower the
throttle and throttle trim. Failure to do so could result in extra damage to
the airframe, as well as damage to the ESC and motor.
Deactivating GPS in Flight
If the GPS system malfunctions while in ight, deactivate it to regain full
manual control.
To deactivate the GPS in ight:
1. Press and hold the HP/AL (bind) button down and fully cycle the
ight mode switch 3 times. The rudder will wag to indicate GPS is
deactivated.
2. Set the ight mode switch to beginner mode for full SAFE Plus function.
The GPS system will remain off until the aircraft is landed and the ight
battery is unplugged and reconnected.
NOTICE: If GPS is deactivated, none of the Virtual Fence modes, Hold
Position mode or Auto Land mode will function. The pilot will have to
manually y the aircraft back to a safe landing.