User Manual

®
EN
6
Installing the Transmitter Batteries
Remove the battery cover, install the four included batteries (noting proper
polarity) and reinstall the battery cover.
Low Battery Alarm
The LED indicator flashes and the transmitter beeps progressively faster as the
battery voltage drops.
Replace the transmitter batteries when the transmitter begins to beep.
CAUTION: NEVER remove the transmitter batteries while the model is
powered on. Loss of model control, damage or injury may occur.
CAUTION: If using rechargeable batteries, charge only rechargeable
batteries. Charging non-rechargeable batteries may cause the
batteries to burst, resulting in injury to persons and/or damage to property.
CAUTION: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to national regulations.
WARNING: Do not pick up the transmitter by the antenna. Do not
alter or put weight on the antenna. Damage to antenna parts can
decrease transmitter signal strength, which can result in loss of model
control, injury or property damage.
Included DXS Transmitter (RTF Version)
RTF Transmitter Control Layout
The diagram shows the control layout of the included DXS transmitter.
Antenna
B Switch (Ch 5 Default)
D Switch (Ch 7 Default)
RGB LED
H Switch
(Throttle Cut Default)
F Switch
(Dual Rate Default)
4 Green LEDs
Throttle/Rudder Gimbal
(Mode 2)
Aileron Trim (Mode 2)
Elevator Trim (Mode 2)
Power Button
Neck Strap Hook
Throttle Trim (Mode 2)
Elevator/Aileron Gimbal
(Mode 2)
A Button
(Channel 6 Default)
Rudder Trim (Mode 2)
Integrated Handle
Wireless Trainer Port
Programming Port
Battery Holder