User Manual

®
EN
4
Charging Warnings
WARNING: Failure to exercise caution while using this product and
comply with the following warnings could result in product mal-
function, electrical issues, excessive heat, FIRE, and ultimately injury and
property damage.
• NEVER LEAVE CHARGING BATTERIES UNATTENDED.
• NEVER CHARGE BATTERIES OVERNIGHT.
• Never attempt to charge dead, damaged or wet battery packs.
• Never attempt to charge a battery pack containing different types of batteries.
• Never allow children under 14 years of age to charge battery packs.
• Never charge batteries in extremely hot or cold places or place in direct sunlight.
• Never charge a battery if the cable has been pinched or shorted.
• Never connect the charger if the power cable has been pinched or shorted.
• Never attempt to dismantle the charger or use a damaged charger.
• Always use only rechargeable batteries designed for use with this type of charger.
• Always inspect the battery before charging.
• Always keep the battery away from any material that could be affected by heat.
• Always monitor the charging area and have a fire extinguisher available at all
times.
• Always end the charging process if the battery becomes hot to the touch or
starts to change form (swell) during the charge process.
• Always connect the positive leads (+) and negative leads (–) correctly.
• Always disconnect the battery after charging, and let the charger cool between
charges.
• Always charge in a well-ventilated area.
• Always terminate all processes and contact Horizon Hobby if the product
malfunctions.
• Charge only rechargeable batteries. Charging non-rechargeable batteries may
cause the batteries to burst, resulting in injury to persons and/or damage to
property.
• The USB outlet shall be installed near the equipment and shall be easily ac-
cessible.
CAUTION: Always ensure the battery you are charging meets the
specifications of this charger. Not doing so can result in excessive
heat and other related product malfunctions, which can lead to user injury or
property damage.
CAUTION: If at any time during the charging process the battery pack
becomes hot or begins to puff, disconnect the battery immediately
and discontinue the charge process as batteries can cause fire, collateral
damage and injuries.
A
B
A
B
A
B
Charge the Flight Battery
The recommended battery for the HobbyZone
®
AeroScout
™
S aircraft, included
with the RTF version, is an 11.1V, 2200mAh 3S 30C Smart Technology LiPo
battery with an IC3
®
connector (SPMX22003S30). If using a different battery, the
battery should be of similar capacity, dimensions and weight to fit in the fuselage.
The aircraft electronic speed control is equipped with an IC3 device connector.
Ensure the battery chosen is compatible. Always ensure the model balances at
the recommended center of gravity (CG) with the chosen battery. Follow your
chosen battery and battery charger instructions to charge the flight battery.
RTF Smart Technology Battery and S120 Charger,
Specifications and Operation
The Spektrum S120 Smart Technology battery charger included with the RTF
version of the aircraft is compatible only with Spektrum Smart 2-3 cell LiPo
batteries or 6-7 cell NiMH batteries. It is not compaptible with any other battery
chemistries or non-Smart batteries.
A USB power supply is required for use. A USB-C QC type power supply is
recommended for the fastest charge times.
To charge the included flight battery:
1. Using the supplied Type-C USB cable, connect the S120 charger to a USB
power supply (not included ).
2. Insert the Spektrum Smart
Battery IC3 connector
(A) into the charger
IC3 port, and insert the
battery balance lead (B)
into the charger balance
port. Both the IC3 and
balance connectors must
be connected for the
charging process to begin.
The battery may be disconnected from the charger at any time
to stop the charging process.
3. Disconnect the IC3 and balance connectors when the charge and balance
cycles are complete, as indicated by the LED.
4. The LED indicator will glow solid red to indicate a charging error. Follow the
operation steps to ensure proper connection is used to charge the battery.
Refer to the LED indicator table for charger status.
IMPORTANT: Connecting a non-Smart battery will cause a charge error and the
S120 will not recognize or charge the battery.
S120 Specifications
Input USB Type C, power supply not included
Input Voltage 5V-12V
Charge Power 18W max (dependant on power supply)
Compatible USB Power Adaptor 5V/1A, 5V/2A, USB Quick Charge (QC) 2.0/3.0
Battery Connector IC3
®
and balance connector
Battery Types LiPo, NiMH (Spektrum Smart Batteries only )
Cell Count 2-3 cell LiPo
Max Output Voltage 13.05V
Max Output Current Up to 2A
LED Indicator
Power On
USB 5V: White LED
USB Quick Charge 2.0/3.0: Blue LED
LiPo: Purple LED
NiMH: Yellow LED
Battery Capacity
Less Than 25% Single Flash
25% – 75% Double Flash
76% – 99% Triple Flash
Charge Complete Green LED (Solid)
Error Red LED (Solid)
USB-C port LED Indicator
Balance Port
IC3 Charge Port