User Manual

AeroScout S 2 1.1m Trainer

Assemble the Aircraft

Install the Landing Gear

1. Slide the main gear into the slots in the fuselage until they lock into place.

Install the Horizontal Tail

1. Slide the longer of the two included square carbon ﬁber tubes fully into the

hole of either of the horizontal stabilizers. The tube is a friction ﬁt and does

not require any adhesive.

2. Insert the tube through the hole in the vertical tail of the fuselage as shown,

until the previously attached horizontal stabilizer is against the fuselage.

IMPORTANT: The decals on the horizontal stabilizers must face up when the

stabilizers are installed correctly.

3. Slide the opposite horizontal stabilizer over the other end of the tube. Press

the stabilizer halves together until they are both fully seated on the tube

and there is just a small gap between the stabilizers and the fuselage.

2. Insert the nose gear into the wheel collar as shown and tighten the

setscrew against the ﬂat in the gear wire using a Phillips screwdriver.