User Manual

RTF/BNF

When you are ready to land or your ﬂ ight timer has

signaled, press and hold the red HP/AL button on the

transmitter for 4 seconds.

The aircraft will instantly respond and begin an

upwind landing approach to return to the initialization

point/location. The aircraft will land into the wind

near your initialization point/location and come to a

complete stop.

When AutoLand is activated, you can still control the

aircraft to avoid obstacles like trees or poles. Once

clear of the obstacles just let go of the control sticks

and the AutoLand feature will take over and resume

the landing.

At any time you can abort a landing by pressing and

releasing the HP/AL button or by changing the ﬂ ight

mode.

If you want to takeoff again after landing pull the

throttle to low position and then press the red HP/AL

button again to deactivate AutoLand.

IMPORTANT: If your aircraft does not

respond immediately to an AutoLand

command, the GPS signal may have been

lost. Release both transmitter sticks and

slowly reduce throttle to gently glide the

aircraft to the ground.

IMPORTANT: The AutoLand feature can not be initi-

ated when your aircraft is below an altitude

of approximately 20ft (6m).

NOTICE: The AutoLand feature does not possess the

ability to avoid obstacles. Ensure that your ﬂ ying

location is free of obstacles (trees, buildings, etc)

before you start ﬂ ying.

6ft (2m) power is cut.

Approximately

30ft (9m)

AutoLand (AL)

Wind

Approximately

65ft (20m)

Press

and hold

for 4 sec.

Press and

Release to

abort.