User Manual

EN
22
®
Appendix
Motor Service
Disassembly
CAUTION: DO NOT handle the propeller
while the fl ight battery is connected to the
ESC. Personal injury could result.
Propeller Removal
1. Disconnect the battery.
2. Remove the Spinner (A), Prop screw (B), Propeller
(C) and Spinner backplate (D) from the propshaft.
Since the propeller and spinner are glued together,
glue residue may need to be cleaned from the
spinner or propeller when these parts are
used again.
Motor Removal
1. Carefully cut the tape and/or decals on
the side of the fuselage to remove the
top of the fuselage.
2. Disconnect the motor wire connector
from the ESC/receiver connector.
3. Remove the screw (E) and motor (F) from the
motor mount.
4. Remove 3 screws (G) and the prop adapter (H)
from the motor. The motor magnet may attract
screws to the motor.
Assembly
Assemble in reverse order.
• Connect the motor wire connector to the
ESC/receiver.
• The propeller size numbers (5 x 2.75) must
face out from the motor for correct propeller
operation.
• Attach the spinner to the propeller using foam
safe CA (cyanoacrylate adhesive) Dynamite
®
foam safe CA, thick DYNK0046.
• Ensure the propeller adapter and motor mount
are fully connected to the motor.
• Re-assemble the fuselage using clear tape.
A
B
F
E
H
G
C
D