User Manual

EN
6
®
IMPORTANT: The installed receiver
has been programmed for operation
specifi cally in this aircraft.
To operate the SAFE
®
Plus system
in this aircraft, set up your optional
DSMX
®
/DSM2
®
transmitter using the
chart below.
- SAFE Flight mode is selected
using Channel 5 signal (high,
middle, low)
- Holding Pattern and AutoLand
are selected using Button I
(channel 6, Aux 1)
IMPORTANT: A transmitter with a
2-position Channel 5 switch will only
allow the use of position 0 (Beginner
Mode) or position 2 (Experienced
Mode) fl ight modes. If possible
assign Channel 5 in your transmitter
to a 3-position switch to operate
all 3 fl ight modes (refer to your
transmitter’s manual).
Refer to your transmitter’s manual for
more information about transmitter
setup.
Transmitter Setup
Non Computerized Transmitter Setup (DX5e)
Transmitter
SAFE Plus
mode switch
SAFE Plus Flight
Modes Supported
Throttle, Aileron, Elevator and Rudder in Normal Position
DX5e
(2 pos switch)
CH 5 switch
0 Beginner
1 Experienced
DX5e
(3 pos switch)
CH 5 switch
0 Beginner
1 Intermediate
2 Experienced
Computerized Transmitter Setup
(DX6, DX7 (Gen 2), DX8 (Gen 2), DX9, DX18 and DX20)
Start all transmitter programming with a blank model (do a model
reset), then name the model.
DX6
DX7 (Gen2)
DX8 (Gen2)
DX9
DX18
DX20
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Go to CHANNEL ASSIGN:
click NEXT to go to Channel Input
Confi g: GEAR: B, AUX1: i
4. Go to the FUNCTION LIST
5. Go to SERVO SETUP: Reverse AUX1
Resulting in:
HP/AL button
Flight Modes
Switch B operates the 3 SAFE
Plus modes (0 beginner/1 inter-
mediate/2 experienced)
Button I commands Holding Pat-
tern/Autoland
BNF AIRCRAFT ONLY