User Manual

5
Step 1
6
Step 2
Installation
• Install the eight 3mm x 10mm Phillips
head machine screws into the
floats making sure the screws are
tightening against the flat spots on
the wires.
• Install 10 x 8 propeller included with
the float kit*. Do not use the 9 x 6
prop included with the airplane as
there will not be enough power to
successfully fly on floats.
* When using the 10 x 8 propeller, it is
essential that you allow approximately
10–15 minutes between flights in order
to allow the 480 motor to properly cool.
Failure to follow this warning will greatly
reduce motor life.
• Remove the landing gear and
landing gear covers from your
Super Cub.
• Insert the front landing (wider) gear
wire of the floats into the front
landing gear slot.
• Insert the rear landing gear wire into
the rear float mount in the fuselage.
Rear Float
Mount
• The Super Cub LP (blue Super Cub
with Li-polymer battery) comes with
the rear float mount pre-installed in
the fuselage. If you are attaching
your Super Cub floats to an original
red Super Cub (HBZ7100), a rear float
mount will have to be installed into
the fuselage. This is a separate part
that has been included with this float
set. Please see page 9 for installation
instructions.