User Manual

9 10
When finished flying off water check all
components for water, if any water is in
the airplane or around the battery
cavity, dry with a paper towel.
Check for water inside the floats. The
joint between the plastic bottom surface
and the foam structure has been sealed,
but if for some reason that seal has
been broken, water could build up
inside the float. This could cause
serious weight gain and/or CG issues.
Installing Floats on the Red and White Super Cub
If installing floats on your red and white
Super Cub (HBZ7100), you will need to
install the included rear float mount on
the fuselage.
Note: We recommend you change the
receiver unit in your red and white
Super Cub to the receiver unit in the
Super Cub LP. You will also need to use
the 3S 11.1V Li-Po Battery (PKZ1033)
The ESC auto cut in the original Super
Cub has been set for Ni-MH cells and
can cause permanent damage to a Li-Po
battery pack if flown to the low-voltage
cutoff point.
Measure back 5 3/4 inches from the
rear of the slot for the original landing
gear. Place the front edge of the rear
float mount at this distance and press
the rear mount into the fuselage of your
Super Cub.
Note: The rounded corners will be facing
forward.
Success Tips (continued)