User Manual

13 14
Glue the rear float mount into the
fuselage using epoxy, making sure not
to get epoxy in the screw holes. Go to
the assembly and installation section
when done mounting the rear float
mount into your Super Cub.
Note: The rear float mount will rest on top of
the foam and not be recessed into the
bottom of the fuselage.
• Do not y off of water if you are
uncomfortable flying the Super Cub
on land. Only use the floats if you can
fly the Super Cub without having any
incidents and can take off and land
smoothly and multiple times in a row.
• Do not y in wind over 5–7 mph
(8-11km/h) as wind will cause larger
waves and make the plane more
susceptible to flipping over.
• Always stay clear of the propeller.
• Always select wide open spaces.
• Always follow all aircraft instructions
when using the floats.
• Always y your aircraft responsibly.
• Stay away from boat wake as it may
cause the airplane to flip or splash
water into the airplane and on the
electronics.
Warnings and Saftey
• Always check the bottom of the oats
each time you pull the airplane out
of the water to check if there is any
damage from hitting submerged
sticks or rocks. If water is found in a
float, it needs to be carefully
removed before the next flight.
• Never attempt to swim out to your
airplane in the water. Use a boat,
RC boat or fishing pole to retrieve
your airplane. Also be aware that
the airplane is still powered up when
retrieving it.
• Never retrieve the airplane alone.
Always have another person with you
to assist in retrieval.
• If the motor of the airplane gets
wet, do not power up to get the
airplane back to the shore. It is
possible to burn up the motor if it is
run while wet.