User Manual

2-3-0-1140/ISS3/NOV09
HOCHIKI ADDRESSABLE POWERED
SINGLE INPUT MODULE
INSTALLATION INSTRUCTIONS
Product Covered: CHQ-SIM
Introduction
The CHQ-SIM has been designed to allow a single monitored input to be connected to the ESP loop. This provides a
compact, low-cost option where the installation of the larger CHQ ‘Smart-Fix’ Range of Modules would be difficult.
Fixing & Wiring
The CHQ-SIM features two colour-coded flying leads, which must be wired as per the product label and as shown below
in Fig 1. The unit also features a wiring terminal block for loop connection:
Fig 1 CHQ-SIM Wiring
The unit can be fixed to most fixing surfaces with two screws (not supplied) by utilising the two fixing holes (see Fig 1).
End Of Line Devices
The following End Of Line (EOL) devices are supplied with the CHQ-SIM and, if the device inputs are being utilised,
should be fitted as follows:
Fit a 10KΩ resistor to the input at the furthest end of the cable from the device.
Fit a 470Ω input activation resistor to the input cable.
Programming
The CHQ-SIM is addressable and features a programming connector to facilitate this. Connect a Hochiki TCH-B100
Hand Held Programmer to the CHQ-SIM using a PL-3 Programming Lead. Refer to the TCH-B100 Instructions for
further details on programming addresses. The programmed address can be written on the device label.
Please note that if the PCB is removed from the protective outer casing the EN54 approval is voided.
CHQ-SIM 0832-CPD-1116 09 EN54-18:2005
Hochiki Europe (UK) Ltd
Grosvenor Road, Gillingham Business Park,
Gillingham, Kent, ME8 0SA, England Telephone:
[phone] Facsimile: [phone]
Email: [e-mail]
Web: www.hochikieurope.com
Hochiki Europe (UK) Ltd. reserves the right to alter the
specification of its products from time to time without notice.
Although every effort has been made to ensure the accuracy of
the information contained within this document it is not warranted
or represented by Hochiki Europe (UK) Ltd. to be a complete and
up-to-date description. Please check our web site for the latest
version of this document.