PATENT PENDING 2nd floor, Building 12, Xicheng Industrial Area, Xixiang Town, Baoan District, Shenzhen Guangdong China. 518101 E-mail: nancy@xviveaudio.
MANUAL INEAR MONITOR WIRELESS SYSTEM
This Class B digital apparatus complies with Canadian ICES-003. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK: DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTSINSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CERTIFICATION 210-135155 Radio Approvals: FCC Part 15.249, FCC Part 15 B, RSS-210 (Canada), EN 300 440 (Europe), EN 301.
FCC CERTIFICATION THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. WARNING: Changes or modifications not expressly approved in writing by Xvive may void the users authority to operate this equipment.
IMPORTANT SAFETY INSTRUCTIONS PLEASE READ THESE INSTRUCTIONS IN A SAFE PLACE WARNING: BEFORE USING YOUR XVIVE U4 MICROPHONE WIRELESS SYSTEM, CAREFULLY READ THE OPERATING INSTRUCTIONS. 1. Observe all instructions carefully in the U4 set manual. 2. Do not to perform service operations beyond those described in the U4 set manual.
WARNING U4 SET PRODUCT INTRODUCTION LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE. Over exposure to excessive sound levels can damage your ears resulting in permanent noise-induced hearing loss. Do not use earphones for a long time and set the volume below 70% or lower.
BASIC OPERATION U4 TRANSMITTER 2 1 3 4 6 5 7 8 9 1 Input: XLR balanced input jack 2 Spring: Circumferential ground spring providing an 3 Lock: secures transmitter 4 Aux/Line mode: Connect to Aux or line out 5 Power switch: switches unit on/off 6 Channel status LED: indicates selected channel 7 Channel switch: selects Channels 1-6 8 USB charging port 9 Power status LED: indicates power status: accurate connection to the mating shell Led off = 100% ~ 30% 10 Solid red = 29% ~ 11% Fl
BASIC OPERATION U4 RECEIVER 1 1 Power switch: switches unit on/off 2 Headphone Output: 3.
QUICK START BATTERIES AND CHARGING U4 provides USB charging cable,you can connect to USB Charger Adapter or other USB charging devices Note: Turn off the power switch while charging. Please do not use U4 when charging, which may reduce battery life. OFF ON POWER ON POWER ON Connect to the socket * Always store U4 at room temperature * When storing the unit, please check the battery state regularly and charge if necessary.
CHANNEL SWITCH PAIR TRANSMITTER AND RECEIVER 3 5 2 6 1 4 U4 has six channels. Use the channel switch button to switch the channel. Set the Receiver channel same with Transmitter. The blue Led signal on the receiver will always be on when the connection is successful. CHANNEL SWITCH SINGLE TRANSMITTER AND MULTIPLE RECEIVERS If you want to add more receiver, just set the receivers to the same channel as the transmitter. MAX.
QUICK START VOLUME ADJUSTING LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE. ADJUST TRANSMITTER LEVELS Adjusting Gain and Listening Volume For the best audio quality, start by adjusting the levels from the mixer or audio source and maximizes the signal-to-noise ratio. VOLUME SWITCH <70% Please do not adjust the volume to more than 70%. 09 Line (+4 dBu) Use with mixers or other professional audio devices that send line-level signals.
OPERATION CREATING MONITOR WITH AUX 1. Transmitter connect Mixer Aux send 2. Trun on the Receiver, adjust the volume of the Receiver, and gradually increase from small to large to reach the appropriate volume state 3. Adjust mixer each Aux channel output levels, mixer and send the signal to Transmitter。 Note: The channel faders on most mixers do not affect the volume of the Aux sends.
OPERATION MIAN OUTPUT CREATING MONITOR WITH XLR 1. Transmitter connect Mixer output or other XLR output 2.
OPERATION CHANNEL 1 MULTIPLE TRANSMITTER AND MULTIPLE RECEIVERS When performers have different monitoring needs, they can set up multiple transmitters. If the receiver is set to the channel corresponding to the transmitter, the audio can be received. Or creat mute rehearsal system.
2.4 GHz SPECTRUM OVERVIEW AND INTERFERENCE U4 operates within the 2.4GHz ISM band which is utilized by Wi-Fi, Bluetooth, and other wireless devices. 2.4GHz is an open band and, as such, does not require a license to be used worldwide. Tips and Methods to Improve Wireless System Performance 1) Keep more than 3 meteres distance between Receiver unit and other WiFi transmitters such as routers. 2) Change channels to avoid interference with other WiFi products.
TROUBLESHOOTING ISSUE No Sound SOLUTION • Check that the U4 Receiver's RF LED is lit. • Check whether the device has a signal sent to the transmitter • Check that the power switch is turned on for both the Transmitter and the Receiver. • Ensure that the U4 Transmitter and Receiver are on the same channel.
SPECIFICATIONS U4 WIRELESS INEAR MONITOR SYSTEM Tuning Bandwidth 2400 – 2483.5MHz Working Range Up to 90ft Actual Range Depends On Rf Signal Absorption, Reflection And Interference. Audio Frequency Response 20Hz – 20KHz(-3dB). Dynamic Range & Signal-To-Noise Ratio 107dB Battery Life 5 Hours of battery life RF Sensitivity -88dBm Total Harmonic distortion 0.2% RF Output Power 10 mW E.I.R.P. max Operating Temperature Range -18℃ to 57℃. Battery Characteristics May Limit This Range.
U4 TRANSMITTER U4 RECEIVER Dimensions 30 X 28 X 100 mm 47 X 41 X 60 mm Weight 90g 118g Housing Molded plastic and cast metal Molded plastic and cast metal Battery 3.7V Rechargeable Li-ion, 860mAh 3.7V Rechargeable Li-ion, 1200mAh Impedance Input 47kΩ(1KHz) 6-600Ω Audio input Connector Balanced XLR Male input 3.5mm stereo output Audio output Connector Mode Aux mode: -10dBV | Max. +12.2dBu Line mode: +4dBu | Max.
U4 SERIES U4 SET 1 Transmitter U4R2 1 Receiver U4 standard set to create personal Monitoring system 17 1 Transmitter 2 Receiver U4R2 set to create small monitoring system Or backup receiver
WIRELESS INEAR MONITOR SYSTEM U4R4 1 Transmitter U4T 4 Receiver 1 Transmitter U4R4 set to create performance monitoring system Or mute rehearsal system Transmitter only, you need to purchase Additional receivers for use U4R 1 RECEIVER Receiver only, you need To purchase additional Transmitter for use 18