rev 200SG KIT-AA REV High Performance Front Speaker and Amplifier Kit For Use On 1998-2013 “batwing” model bikes with factory radios installation Manual
Thank you for choosing the Hogtunes REV 200SG Kit-AA for 1998-2013 “Batwing” Model Bikes. Since positive word of mouth is the best way to grow our business, we want your new system to work as well as it was designed to. If you have any questions or concerns, we are here to help. The REV 200-AA Amplifier is a Class D design. We chose this design because it yields plenty of power, is easy on the bikes charging system and produces little heat.
getting started Step #1: Remove the seat and both wires (+ and -) from the battery. Step #2: Remove the outer fairing/headlamp assembly and set it aside. Refer to a service manual if you need help with this. NOTE: A towel on the front fender can help prevent scratches or “dings” from dropped tools or fasteners etc. Expletives will also be kept to a minimum! Step #3: Take the 2 wires off each front speaker by gently pulling one at a time.
Amplifier wiring diagram Brake-side factory speaker wire plugs into green/black on amp Clutch-side factory speaker wire plugs into yellow/black on amp Orange wire goes to center pin on cigarette lighter Power and ground DIRECT to battery Blue/Black wire plugs into Brake side speaker Brown/Black wire plugs into clutchside speaker Optional HF-1 Tweeter Pod 4
Wiring the Amplifier Step #1: Locate the main power harness and plug it into the matching connector on the amplifier. Locate the 8 pin harness and plug it into “Audio Input” on the side of the amp. Step #2: • • • On the audio input harness, locate the yellow/black pair of wires with the male connectors. Unplug the factory speaker wires on the clutch side of the bike and plug the yellow/black wires in to those. They will only go in one way.
Routing the power harness For ‘98-’06 bikes, the power harness will pass under the inner fairing where the throttle and idle cables pass through on the brake side of the bike. The harness is designed to be routed between the frame backbone and gas tank on the brake side of the bike and come out just behind the gas tank. You MAY need to undo the back bolt of the gas tank and pivot the tank up to allow the harness to pass through at the back of the gas tank.
system upgrade #1 This system is an easy way to add rear speakers to your bike if you’ve added a King Tour-Pak®. Hogtunes rear speaker pods come with a wire harness set up for quick detach tour paks that will plug right into the expansion port on the amp.
system upgrade #2 This system has the incredible power of 2 REV 200-AA Amplifiers to your bike! The first amp will run the 5.25” fairing speakers and HF-1 Tweeter Pod (if present). The second amplifier is used to power a set of 692.2/Lids, FL-7W fairing lower woofers or rear tour pak speakers.
system upgrade #3 This system adds a Hogtunes 4 channel amp; where 2 of its channels would power the front speakers (and tweeter pod if present) and the other 2 channels would power rear speakers or fairing lower woofers. The original 2 channel amp would power 692.2/lids or lower speakers. You can literally build the system the way you want based on the body work you have on your bike.
Adjusting Your System-Please Read! In order to make your new system perform as good as it was designed, please take a minute to understand and follow these tips: 1) S et your “Automatic Volume Control” (AVC) to 3 bars. After extensive on-road testing, we found that this AVC position works and sounds best. Your new amplifier has been specifically set-up for this radio setting. 2) Y our Hogtunes system is designed specifically for a motorcycle at speed.
Technical Specifications Hogtunes REV 200-AA Amplifier RMS Power at 2 Ohms:................100 watts x 2 Freq. Response:..........................30hz-25khz Fuse at Amp:..............................15 amp Hogtunes 352F-AA Front Speakers Power Handling: ........................100 RMS-150 Peak Frequency Response: ..................55hz-25Khz Sensitivity: .................................92 db 1watt/1meter Nominal Impedance: ..................2.0 Ohms Cool Factor:...............................
Hogtunes products will play much louder than the Original Equipment, which can be a distraction to the rider and/or passenger. Please use caution when adjusting, or playing your stereo at high volume, especially in traffic. You are a valued customer so please: Ride Alert Arrive Alive! www.hogtunes.
