REV 200SG Kit-RM High Performance Front Speaker Kit with 200 Watt Amplifier For ForUse Use On On 1998-2013 rushmore Ultra Classics platform And Tri-Glides models installation Manual
Thank you for choosing the Hogtunes REV 200SG KIT-RM speaker and amplifier kit for “Rushmore” platform bikes. Since positive word of mouth is the best way to grow our business, we want your new system to work as well as it was designed to. If you have any questions or concerns, we are here to help. The installation will be done in 3 major steps.
362F-RM Front Speaker Installation Instructions Step #1: Remove the seat and both wires (+ and -) from the battery. Remove the outer fairing/headlamp assembly and set aside. Refer to a service manual if you need help with this. NOTE: Placing a towel on the front fender can help prevent scratches or “dings” from dropped tools or fasteners, etc.
Step #3: Installing the New Speaker: With the cabinet removed from bike undo the four screws that hold the factory speaker to the cabinet. Carefully take off each speaker wire by disconnecting one at a time. Take a Hogtunes speaker and attach the factory speaker wires, noting they will only go on one way. The #1 reason for tech related calls is loose wires at the speaker which is why we designed the self-locking clips on the speaker frame.
REV 200-RM amplifier Installation Instructions Step #1: Over top of the radio, pull up to release each wire harness from the black plate via the factory “Christmas Tree” fasteners. If your bike has factory GPS, the small square antenna will need to be relocated just behind the voltmeter as shown in Fig 1.1 below. Remove the four factory T-20 “Torx” screws that go through the top of the black plate and into the top of the radio. Step #2: Figure 1.
Step #4: Figure 1.2 shown here. Figure 1.2 - Amplifier and mounting plate correctly oriented. The plate with four small holes is for mounting a popular Harley accessory. The white circles show tabs which are there for the “Christmas Tree” fasteners to re-secure the harnesses lifted earlier. Step #5: Also in Fig 1.2 is a white square which shows a smaller black 2 pin factory plug. The orange wire from the amp has a plug that goes directly into this factory harness.
routing the power harness The balance of the main wire harness will pass under the inner fairing where the main wire harness passes through on the brake side of the bike. Loosen the tank console and run wires up and over the gas tank, but under the tank console. There is a provision on the front of the tank console for wires to pass. Secure the amplifiers harness to the bikes factory harness using zip ties. When correctly installed, the power and ground wires are the right length to connect to the battery.
Adjusting Your System-Please Read! In order to make your new system perform as good as it was designed, please take a minute to understand and follow these tips: 1) S et your “Automatic Volume Control” (AVC) to 3 bars. After extensive on-road testing, we found that this AVC position works and sounds best. Your new amplifier has been specifically set-up for this radio setting. 2) Y our Hogtunes system is designed specifically for a motorcycle at speed.
Warranty Information Please Record Your Amplifier’s Serial # Here_________________________ Hogtunes speakers are warranted for a period of 20 years. The REV 200-RM Amplifier is warranted for 3 years from original purchase date. Proof of purchase is required for all warranty claims. The warranty applies to the original retail customer and is not transferable. Please contact Hogtunes for all warranty claims.
Any audio system can be a distraction to the rider and/or passenger. Please use caution when playing your stereo, especially in traffic. www.hogtunes.
