User's Manual

If the gimbal vibrates and the bluetooth light flashes by blue and red, the gimbal works
improperly with beeps and turn off automatically after 3 seconds, it would be possible that
your mobile phone is not properly mounted.
1. Mount your mobile phone before powering on the gimbal.
2. Attach your phone, ensuring that your phone is cling to the rubber mat.
3. Balance your phone by sliding the holder to the middle of phone.
4. Unlock all the 3 motors before powering on the gimbal.
*If you mobile phone is lightweight, the gimbal would vibrate while above steps are done
correctly, please adjust the motor response as Medium or Low in the app.
Make sure to connect the gimbal with app successfully, you can find the Motor Response
setting in the Stabilizer Parameter Settings.
4.What to do if the firmware updating failed?
If the firmware updating failed, the bluetooth light flashes red and the gimbal is not able to
work after powering on, please close the app, restart the bluetooth of mobile phone and do
the firmware updating again.
* Make sure the app is not closed, do not switch to other app or turn off your mobile phone
while updating the firmware.