Owner Manual

ManualsBrandsHokku Designs ManualsCoffee Table SetsLatanya 3 Piece Coffee Table Set

Assembly Instructions

ASSEMBLY RA TING

Tools Required For Assembly:





 

 



 O O@@@o1FFICULT

Allen Wrench

(Included) �

2 PERSONS RECOMMENDED

Page 1 of 5

Summary of content (5 pages)

PAGE 1
Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
PAGE 2
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST.CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lock or spring washer is placed between the larger flat washer and the head of the screw or bolt. Position each part correctly and insert screws or bolts into their respective holes by hand tighten or using the proper hand tool.
PAGE 3
PAGE 4
. Prepare 4 bolt assemblies by first inserting a lock washer (#C) onto the bolt (#A) then a flat washer (#B) onto that same bolt (#A). Insert one into each leg and secure. 3. Place the table legs (#3) onto the other ends of the wood dowels (#D). 2. Insert 2 wood dowels (#D) into each corner. 1. Carefully place the coffee table top (#1) face down onto a protected surface. Carefully turn the completed table upright. Make sure the table is rested on a flat surface and does not feel loose or wobbly.
PAGE 5
4. Prepare 4 bolt assemblies by first inserting a lock washer (#C) onto the bolt (#A) then a flat washer (#B) onto that same bolt (#A). Insert one into each leg and secure. 3. Place the end table legs (#4) onto the other ends of the wood dowels (#D). 2. Insert 2 wood dowels (#D) into each corner. 1. Carefully place the end table top (#2) face down onto a protected surface. Carefully turn the completed table upright. Make sure the table is rested on a flat surface and does not feel loose or wobbly.