Installation Guide

Page 5
STEP 11 - Mounting the Fixed Glass Panel:
* Set the Fixed Panel into the Panel Sill:
- Spaced panel 1/8" off of the wall.
- NOTE: 1/8” gap will be filled with silicone during final
steps of installation.
- The Fixed Panel will protrude out of the end of the
channel.
* Holes in the glass should line up with the two Panel
Connectors on the Header Tube.
* If they don't, you may have to raise or lower the Panel
by adjusting the Setting Blocks
* And / Or, adjust puck slot on the wall to raise or lower
Tube to adjust up and down and possibly rotate the Header
Tube to square it up to the panel.
* After the panel is adjusted, secure the Panel to the Header
Tube with Panel Connector Cap. Tighten securely using
Allen wrenches supplied.
* With the top of the Panel secured:
- Loosen blue tape
- Use a rubber mallet and tap the Panel Sill and the
panel at the bottom to the plumb position using a level.
* Securely tape bottom channel to floor with painter’s tape.
STEP 13 - Mounting the Sliding Panels:
* Take the Inside Sliding Panel (14), mount 2 Wheel
assemblies (1) as shown.
* NOTE:
The Wheel will face to the outside of the shower.
* By rotating plate between roller and glass, adjust the
roller so you have equal up and down adjustment.
* NOTE:
Once roller is adjusted to desired height, ensure
inner plate is not rotated.
*
Tighten the roller securely as shown by rotating back cap.
* Repeat for second roller (1). Tighten the rollers securely
using the two 3mm
Allen Wrenches (7f).
STEP 12 - Center Guide:
* Set the Center Guide (5) in place on the threshold and over
the edge of the Fixed Panel.
* NOTE: The Center Guide is reversible by loosening the
set screw and rotating the receiver.
- Open “C” without black insert cups over the exposed
edge of panel.
- Black insert side should point up and be positioned to the
inside of units as shown.
* Mark the hole location and drill with a 3/16” Drill bit. Insert
Wall Anchor (7c).
* Fill Wall Anchor and hole with silicone and put a bead on
the bottom of the Guide.
* Secure guide with one #8 X 1-1/8 FHPH Screw (7b).
1/8” Gap from wall will be
filled with silicone
Fixed Glass Panel
Adjust panel up or down
by adding or reducing
setting blocks in bottom
channel
Adjust panel forward
or backwards to make
panel plumb.
Blue
Painter's
Tape
Installation Instructions
Models: ECTE180 / ECSE180
3/8" Frameless Slider & 180° Panel
Page 7
3mm
Allen
Wrenches