Installation Guide

Page 6
Installation Instructions
All Models
Illustration #9
STEP 9 - INSTALL CENTER GUIDE
a. Move both panels to the middle of the Header Bar.
b. Slide the Center Guide under both panels and align one
of its long edges with the mark made in STEP 2.
c. Use a level to make sure panels are plumb and adjust
the Center Guide to achieve best result.
d. Mark Center Guide edges or outline on the threshold.
e. Remove the Glass Panels. Ensure the Center Guide is
still in place and mark the holes of the Center Guide on
the threshold.
f. Remove the Center Guide and drill a hole at each mark
with a 1/4” drill bit.
g. Fill holes with silicone and insert M4 Wall Anchors.
h. Add silicone to bottom of Center Guide and set in place
on threshold.
I. Secure Center Guide with two M4 X 30mm Screws and
then carefully reinstall Glass Panels.
STEP 10 - ADJUST ROLLERS
a. Holding a level on top of each glass panel, determine if
they are level.
b. If sloped, adjust the Rollers as shown in Illustration 9.
Raise and/or lower each side of the panel until the
panels are level.
Outside Panel
ROLLER ADJUSTMENT
Glass Panel
Header Bar
Inside glass
panel Roller
wheel faces
Outside shower
1. Remove
cap from
roller
2. Loosen center bolt with
5mm hex wrench
4. Tighten center bolt
3. Rotate to adjust panel angle
with 3mm hex wrench
Roller at
Min. Height
Roller at
Max. Height
STEP 8 - INSTALL SLIDING PANELS
a. Starting with the Inside Panel, mount two Roller
assemblies as shown in Illustration 7. The side of the
panel with the wheels will be oriented to the outside of
the shower.
b. Trim two pieces of the Bottom Sweep (ITEM #14) to the
width of the glass panels. Install one around the bottom
edge of the Inside Panel so that the tail is oriented
towards the inside of the shower.
c. Hang Inside Panel on the inner rail of the Header Bar.
d. Mount both wheels onto the Outside Panel using the
same procedure as above. The side of the panel with
the wheels will be oriented to the inside of the shower.
e. Install the other trimmed Bottom Sweep to the bottom
edge of the Outside Panel so that the tail is oriented
towards the inside of the shower.
f. Hang Outside Panel on the outer rail of the Header Bar.
Glass Panel
Illustration #7Illustration #8
Inside
Shower
Enclosure
Outside
Shower
Enclosure
Inside Panel
Showerhead Wall
Wheels