Installation Guide

Page 7
Installation Instructions
All Models
Illustration #12
STEP 12 - INSTALL TOWEL BAR, PULLS, AND VINYL
a. Cut two pieces of Bulb Seal (ITEM #12) to fit the height of the
glass, below and above the header block. Install on either
panel at the edge of the glass that will be closest to the wall at
the closed position. Notch the Bulb Seal to fit around the
Bottom Sweep. Repeat for the other panel.
NOTE: The bulb seal is important to protect the glass from coming
into contact the wall.
b. Optional: Trim the Center Seal (ITEM #11) to fit between the
bottom of the glass and just below the Anti Jump. Install the
Center Seal along the centermost edge of the outer glass
panel when in the closed position. Notch the Center Seal at
the bottom to fit around the Bottom Sweep.
NOTE: The Center Seal may hit the knob of the inside panel.
c. Disassemble the Tower Bar and reassemble it in place on the
outer glass panel. See below (Illustration 12) for proper
sequence.
d. Disassemble the Knob and reassemble it in place on the inner
glass panel.
e. Ensure that the plastic hole grommet is inside the holes of the
glass. Failure to do so could result in the panel chipping or
breaking.
Knob
Knob
Knob
Hole
Grommet
Hole
Grommet
Hole
Grommet
Flat
Washer
Flat
Washer
Flat
Washer
Threaded
Stud
Threaded
Stud
1.
2.
3.
Blind
Fastener
Illustration #11
Trim Bulb Seal
to fit above and
below Header
Block
Trim Center Seal
to just below the
Anti Jump
ANTI JUMP
To adjust Anti Jump, hold
the inner allen wrench
stable while rotating the
outer allen wrench
Adjust by rotating
3mm allen wrench
1/16”
Adjust Anti
Jump to
create a
1/16”gap
to the
Header Bar
Loosen/Tighten
with 3mm allen
wrench
Glass Panel
Illustration #10
STEP 11 - INSTALL AND ADJUST ANTI JUMPS
a. Assemble two Anti Jumps onto each glass panel so that
they are snug but not tight.
b. Rotate outer cam/cap with the provided 3mm hex keys
as demonstrated in Illustration 10 to raise or lower Anti
Jumps until they are approximately 1/16” from the
bottom of the Header Bar.
c. While holding the outer cam/cap in position, tighten the
Anti Jump against the glass.