Installation Guide

Optional: HA.3208 Header Wedge Stabilizer

Page 8

Threshold wall

Measure and cut Soft Sill to this dimension

Soft Sill

Illustration #14

STEP 14 - SILICONE

a. Run a continuous bead of silicone along the bottom outside

and inside of the Soft Sill crossing the Center Guide.

b. Allow silicone to cure for 24 hours before using the shower.

Apply a Single Bead along inside and

outside of Soft Sill and Center Guide

STEP 13 - INSTALL SOFT SILL

a. Measure the distance between the wall and the nearest side

of the Center Guide, see Illustration 13.

b. Cut Soft Sill to this dimension.

c. Repeat for the other side of the Center Guide.

NOTE: Clean adhesion surface with alcohol and dry thoroughly.

d. Peel the backing off the tape on the Soft Sill and stick in

place on the threshold. The outer edge of the Soft Sill should

line up with the outer face of the Center Guide.

e. Repeat for second piece of Soft Sill.

Illustration #13

Installation Instructions

All Models

The Header Wedge Stabilizer consists of a Base and a Wedge. It is an optional accessory that can be used:

If the ends of the header bar rails are bowed inwards and are loose against the sides of the header block.

To help reduce roller noise and potential distortion of the header bar.

Base

Wedge

STEP 1: Insert Base between the

rails of the Header Bar.

STEP 2: Push the Wedge into the

Base until it forces to the rails of the

Header Bar against the sides of the

header block.

STEP 3: Insert the Header

Bracing plate into the slot of the

Header Block and tighten the set

screws