Tractor Operating Instructions

Operating Instructions

145 052 167

C 9700 ... C 9.88 H

Maintenance as required

Changing the Hydraulic Oil Return Filter for Power

Hydraulics*

The hydraulic oil return filter with service indicator is located

at the rear right hand side of the tractor below the cabin.

ATTENTION

The hydraulic oil return filter must be replaced

if the pressure at the service indicator (1) rises

to 3 bar with the installed equipment (eg spi-

ral-bladed lawn mower) at engine idling speed

and the power hydraulics on.

- Relieve any pressure in the hydraulic system by

turning the implement off.

- Loosen the hydraulic oil return filter (2) with a filter

wrench.

ATTENTION

Observe the instructions for handling fuels

and lubricants.

- Clean the mating surface of the filter mount.

- Coat the new seal with oil.

- Install and hand tighten the new oil filter cartridge with

a new seal in the filter mount.

- Make a trial run and check for leaks.

- Check the hydraulic oil level.

* Option

Bild_151