Installation Guide

Solutions to

Shape the World

™

Installation Instructions

HoldRite

HydroFlame

™

Pipe Collar

WALL INSTALLATION

Clean plastic pipe.

Close collars and slide along the

pipe until ush with wall. Anchors as

required.

Apply caulking as required to close

remaining gap to both sides of wall

assembly; providing a re smoke and

gas resistant seal. Spread caulking

smoothly and evenly all around.

Install collars around pipe.

PAGE 1
Solutions to Shape the World™ Installation Instructions HoldRite® HydroFlame™ Pipe Collar WALL INSTALLATION 1 Clean plastic pipe. 4 Close collars and slide along the pipe until flush with wall. Anchors as required. 2 Apply caulking as required to close remaining gap to both sides of wall assembly; providing a fire smoke and gas resistant seal. Spread caulking smoothly and evenly all around. 3 Install collars around pipe.
PAGE 2
Solutions to Shape the World™ Installation Instructions HoldRite® HydroFlame™ Pipe Collar FLOOR INSTALLATION 1 Clean plastic pipe. 4 Close collar and slide along the pipe until flush with bottom of floor. Anchors as required. 2 Apply caulking as required to close remaining gap to the bottom side of floor assembly; providing a fire smoke and gas resistant seal. Spread caulking smoothly and evenly all around. 3 Install collar around pipe from the bottom of floor.