Installation Guide

REMOVE OUTER SLEEVE & UNSCREW CAP.
(Fig. 1)
INSTALL CD PLATE.
(Fig. 3)
Snap CD Plate to bottom of Base, 12 places.
(Optional, #8 screws may be used to increase
attachment strength)
INSTALL INVERTED OUTER SLEEVE TO UNDER SIDE.
(Fig. 4)
Twist Outer Sleeve, clock-wise, until tight.
(Cut short, if desired)
Pull out Locator Whiskers
(optional)
Snap Cap & Locator Whiskers onto Sleeve.
(Optional, screw can be used to strenghten attachment.
Note: Push Cap down onto Sleeve until it snaps on.
Rotate clockwise, slightly, if sesired.
RE-INSTALL CAP & WHISKERS.
(Fig. 5)
CUT HOLE IN METAL DECK.
(SEE SPEC. SHEET FOR HOLE SIZING CHART)
(Fig. 6)
CUT SLEEVE TO DESIRED HEIGHT.
(CAN BE CUT AS SHORT AS 2-1/2")
(Fig. 2)
Hydroflame PRO Series - Metal Deck (pg. 1 of 2). See Hydroflame Pro - "Best Practices" document and UL's online certification directory (file R25101) for more details. Rev B