Use and Care Guide
35
FAX: 760-744-0507 1-800-321-0316 www.HoldRite.com Engineered Solutions
HoldRite
®
HydroFlame™ Pro Series
Non-Telescoping Firestop Sleeves
• Ideal for flat concrete form decks – cast-in-place
• Ideal for corrugated metal decks (corrugated deck plate required)
• Available for ½” to 6” penetrants, piping, conduits, cables, etc.
• For insulated and non-insulated pipes
• 7-3/4” Tall, and can be cut to as short as 2-1/2”. Extensions available
• Black base and black whiskers identifies metal piping system
• Red base and red whiskers identifies plastic or metal piping system
• Includes locator whiskers, to locate buried sleeves and to identify
pipe type (metal or plastic)
• Dimensions on sleeve allows for simple height adjustment when cutting
• Safety caps meet OSHA hole cover requirements
• UL Listed firestop devices (2 or 3 hour F-ratings)
• Meets and/or exceeds building code requirements
• Built in fire, smoke, gas and water protection
• UL W-Rated seal, water-tight for most penetrants
• Allows for contraction, expansion, movement and off-center pipes
• Reduces piping system noise transfer by maintaining annular spacing
• Interlocking base capability assists with layout alignment
• A variety of accessories are available
• UL 50 Pa Ratings
Model Number Penetrating Pipe Type Nominal Penetrant Size Box Qty
HFP-P1B Plastic and Metal 1/2” - 1” 10
HFP-P2B Plastic and Metal 1-1/4” - 2” 10
HFP-P3B Plastic and Metal 2” - 3” 10
HFP-P4B Plastic and Metal 3” - 4” 10
HFP-P6B Plastic and Metal 5” - 6” 2
HFP-M1B Metal 1/2” - 1” 10
HFP-M2B Metal 1-1/4” - 2” 10
HFP-M3B Metal 2” - 3” 10
HFP-M4B Metal 3” - 4” 10
HFP-M6B Metal 5” - 6” 2
Type UL Rating Status
Water W
Smoke /Gas L
Fire F
Thermal T*
*T-Rating when penetrant is non-metallic
1
5
2 3 4
Cut sleeve if desired
height is under 7¾”
Re-install cap & insert whiskers
Install pipe
Nail to form deck
Remove cap with Safety Cap Tool
or break out with hammer