User Manual V2.
* The configuration is based on the product package and is subject to the actual quantity of equipment purchased.
LARK C1 SOLO (TX*1 to RX*1) Wireless Microphone System Transmitter *1 Furry Windshield *1 Receiver *1 Storage Case *1 USB-A to USB-C Cable *1 User Manual *1 ⑦ Warranty Card *1 * The configuration is based on the product package and is subject to the actual quantity of equipment purchased.
LARK C1 DUO (TX*2 to RX*1) Wireless Microphone System with a Charging Case Charging Case *1 Furry Windshield *2 Transmitter *2 Storage Case *1 Receiver *1 USB-A to USB-C Cable *1 ⑦ User Manual *1 ⑧ Warranty Card *1 * The configuration is based on the product package and is subject to the actual quantity of equipment purchased.
PRODUCT INTRODUCTION TX 2 TX 1 RX (Android/iOS) Charging Case Built-in Microphone Power Button Press and hold the power button for 3s to turn on/off the device.
PRODUCT INSTALLATION The TX automatically turns on after it is taken out of the charging case. Simply clip the TX on the cloth. Connect the RX to a mobile phone. Charge the mobile phone via the RX.
PRODUCT FUNCTION Noise Cancellation Function ◆ Steady Blue Light: Device connected/Smart noise cancellation off by default ◆ Steady Green Light: Smart noise cancellation on Press the yellow button on the TX to enable the smart noise cancellation function. After the function is enabled, the indicator light turns green.
PRODUCT FUNCTION Manual Pairing After the receiver is connected to the mobile phone, press and hold the ‘ and the ‘ ’ button on the RX for 3s. ’ button on the TX * The TX and RX have been paired with each other in the factory before shipping. They need to pair with each other again if they are disconnected.
Wireless Transmission Transmission Range Built-in Microphone 2.4GHz Adaptive Frequency Hopping (AFH) 130ft (40m) for NLOS/650ft (200m) for LOS Polar Pattern: Omnidirectional Frequency Range: 20Hz–20kHz Maximum SPL Input Dynamic Range Battery Capacity 110 dB 86 dB TX: 140 mAh (0.518 Wh) Charging Case: 1400 mAh (5.18 Wh) Operating Time TX: 8H Charging Case: Maximum 3 times of charging for 2 TX TX: 1.5H Charging Case: 1.5H Charging Time Dimensions Weight TX: 48x21.5x10mm (1.89"x0.85"x0.4") RX: 48.3x27.
APP LarkSound Developed exclusively for Lark wireless microphones, the LarkSound app is a perfect design to work together with the microphones. Various functions, such as smart mode setting, parameter configuration, and firmware upgrade, can be achieved in LarkSound. iOS device version: v12.0 or later Android device version: v8.
If you encounter any problems in using the product, please contact Hollyland Support Team via the following ways:
Note: The frequency range and wireless TX power of the device vary by country and region. Safety Precautions Do not place the product near or inside heating devices (including but not limited to microwave ovens, induction cookers, electric ovens, electric heaters, pressure cookers, water heaters, and gas stoves) to prevent the battery from overheating and exploding. Do not use non-original charging cases, cables, and batteries with the product.
FCC Requirement s are s.
