User guide

10: Trike Adapter
Note: Rack will hold 1 adult trike or
1 recumbent trike. When carrying a trike,
DO NOT attempt to carry additional bike(s).
Installation Procedure:
A. Remove all wheel holders except the
driver’s side outer wheel holder (Fig. 13a).
B. Slide the long trike bar onto the passenger
side of the rack as shown in fig.14. Snug up
set screws (Fig. 14a) but do not tighten.
C. Slide short trike bars onto ends of the long
trike bar tube as shown in fig. 14. Install wheel
holders onto short trike bar as shown in Fig.15.
D. Slide wheel holders onto short trike bars as
indicated in Fig. 14 and Fig. 15. Tighten knob
securely.
E. Install bolt and nut onto end of short trike bar.
Measuring and set-up:
F. Measure the distance between the wheels
(Dimension A, Fig. 16, 17) and adjust the
distance between the short trike bars
accordingly. Tighten set screws (Fig. 15a).
G. Measure the wheelbase (distance between
the 2 axels) on your trike. This will correspond to
Dimension C on Fig. 16,17.
H. Most of the weight on recumbents are in the
rear wheels, so it is very important that you
attempt to position the rear wheels as close to
the center of the rack as possible. This will
correspond to dimension B in Fig. 16, 17).
However, be careful to not allow the front wheel
to extend beyond the side view mirror.
Fig. 13
Fig. 14
Fig. 14a
Fig. 15
Fig. 15a
Fig. 15b
Fig. 17
Fig. 16
Fig. 13a