Manual

ManualsBrandsHollywood Racks ManualsFor bicyclesHR135 Tow N Go (3 bike version)

FIG. 1:

Black

threaded k

nob

and

spacer block

Tow ‘n Go Hitch Rack

Model HR135 For 2” hitches only

Assembly and Use Instructions for Traveler Style Tow ‘n Go Hitch Rack

 Drive slowly when using the rack on bumpy or dirt roads.

 Check the rack bikes and straps regularly during use.

 If you have any questions or installation problems, please see your Hollywood Racks retailer or

contact Hollywood Racks at 800-747-4085.

Class III Hitch Required if you tow and carry bikes at the same ti

me. A

longer hitch ball mount may be required for use of this product. (Tow N’ Go

requires 3” of space on your hitch ball mount insert tube)

After opening the Tow N’ Go box, you should

have the following parts:

1. Parts bag including:

a. Two black threaded knobs

b. Two pivoting spacer blocks

c. Allen wrench for set screws.

2. Upright “T” shaped main beam

3. Two Support arms with bike separators

attached.

4. Nine rubber straps & Safety tie-down strap

Summary of content (4 pages)

PAGE 1
Tow ‘n Go Hitch Rack Model HR135 For 2” hitches only Assembly and Use Instructions for Traveler Style Tow ‘n Go Hitch Rack    Drive slowly when using the rack on bumpy or dirt roads. Check the rack bikes and straps regularly during use. If you have any questions or installation problems, please see your Hollywood Racks retailer or contact Hollywood Racks at 800-747-4085. Class III Hitch Required if you tow and carry bikes at the same time.
PAGE 2
) Installing the support arms: Insert the knob through the spacer as shown in Fig. 1 (the knob should be against the flat end of the spacer block). Align the threaded hole in the vertical cylinder (fig. 2) so that it faces out. You can rotate the vertical cylinder using a coin or flat blade screwdriver in the slot at the top of the vertical cylinder. Insert the knob through the support arm, and thread the knob into vertical cylinder inside the main top horizontal tube. Repeat for the Driver’s side arm.
PAGE 3
For ease of installation, we suggest you put the larger bikes on the inside (closest to vehicle), smaller frames or kids bikes on the outside. The first bike loaded should have the handlebars facing towards the driver’s side of the vehicle. Place the top tube (or closest appropriate frame tube) onto the bike cradles, pull the straps over the bike tube and attach to the tab on the opposite side of the cradle. Use a strap notch-hole that provide a snug fit, but take care not to pull the strap over-tight.
PAGE 4
Limited Lifetime Warranty (effective January 1, 2008): Hollywood Racks will warrant its car racks and accessories during the time that an original retail purchaser owns the product subject to the exclusions and limitations of this warranty. Hollywood Racks will remedy defects in materials and workmanship by repairing or replacing (at its option) a defective part or the complete rack without charge for labor or parts.