Manual

ManualsBrandsHollywood Racks ManualsFor bicyclesHR135 Tow N Go

Tow ‘n Go Hitch Rack

Model HR135 For 2” hitches only

Assembly and Use Instructions for Traveler Style Tow ‘n Go Hitch Rack

 Drive slowly when using the rack on bumpy or dirt roads.

 Check the rack bikes and straps regularly during use.

 If you have any questions or installation problems, please see your Hollywood Racks retailer or

contact Hollywood Racks at 800-747-4085.

Class III Hitch Required if you tow and carry bikes at the same time. A

longer hitch ball mount may be required for use of this product. (Tow N’ Go

requires 3” of space on your hitch ball mount insert tube)

Note: This product not to be used on the back of trailers!

Summary of content (5 pages)

PAGE 1
Tow ‘n Go Hitch Rack Model HR135 For 2” hitches only Assembly and Use Instructions for Traveler Style Tow ‘n Go Hitch Rack    Drive slowly when using the rack on bumpy or dirt roads. Check the rack bikes and straps regularly during use. If you have any questions or installation problems, please see your Hollywood Racks retailer or contact Hollywood Racks at 800-747-4085. Class III Hitch Required if you tow and carry bikes at the same time.
PAGE 2
009 version Qty Description 1 Tow ‘n Go bike rack with Tie Down strap attached to rack 9 Rubber Bike Cradle straps 1 Allen wrench for set screws Fig. 1 Installation Instructions: 1. Install your trailer hitch receiver tube through the base of the rack (at the bottom of the main beam. See Fig. 1 2. Locate the base as far forward as possible. 3. Using Allen wrench supplied, tighten the 4 set screws on the base unit until snug. Fig. 2a Support Arms (Fig. 2.
PAGE 3
2006 through 2008 version After opening the Tow N’ Go box, you should have the following parts: FIG. A: Black threaded knob and spacer block 1. Parts bag including: a. Two black threaded knobs b. Two pivoting spacer blocks c. Allen wrench for set screws. 2. Upright “T” shaped main beam 3. Two Support arms with bike separators attached. 4. Nine rubber straps & Safety tie-down strap Fig. B Vertical Cylinder Installing the support arms: Insert the knob through the spacer as shown in Fig.
PAGE 4
Installation of bikes – all versions For ease of installation, we suggest you put the larger bikes on the inside (closest to vehicle), smaller frames or kids bikes on the outside. The first bike loaded should have the handlebars facing towards the driver’s side of the vehicle. Place the top tube (or closest appropriate frame tube) onto the bike cradles, pull the straps over the bike tube and attach to the tab on the opposite side of the cradle.
PAGE 5
Removing the bikes and rack: To remove bikes, simply undo the rubber straps and gently lift bikes off. Be sure to fold down the support arms so as to minimize the length of the rack when not in use. To remove the rack from vehicle, remove hitch pin and slide rack out of receiver hitch. Avoid sharp backup angles when carrying bikes! Be aware that your bike’s wheels may be damaged when backing up at extreme angles.