User Manual

ManualsBrandsHollywood Racks ManualsFor bicyclesHR1450 SportRider SE

Hollywood Racks Sport Ride

r Hitch Rack Instruction Manual

Model HR1450 - 2 Bike Capacity, 2” receiver (4 bike capacity when used with HR1475 two bike add on kit)



Not to be used on any

trailer, fifth wheel or vehicle

being towed by another

vehicle

 Weight Limit 45 lbs/20 kg

per bike

 2 bike maximum capacity

 4 bike maximum capacity

when used with HR1475

two bike add on kit (sold

separately)

PARTS LIST

Item Description Qty Item Description Qty

A vertical post 2 H receiver tube 1

B base assembly 1 I pivot nut 1

B1 Front Cap 1 J pivot washers 2

C short hook clamp 2 K locking hitch pin 1

D long hook clamp 2 L security cable 1

E left wheel holder 4 M wheel support tube 4

F right wheel holder 4 N extension lever 1

G pivot bolt 1 P “stop” screws 2

R clip 2

Summary of content (6 pages)

PAGE 1
Hollywood Racks Sport Rider Hitch Rack Instruction Manual Model HR1450 - 2 Bike Capacity, 2” receiver  Not to be used on any trailer, fifth wheel or vehicle being towed by another vehicle  Weight Limit 45 lbs/20 kg per bike  2 bike maximum capacity  4 bike maximum capacity when used with HR1475 two bike add on kit (sold separately) (4 bike capacity when used with HR1475 two bike add on kit) PARTS LIST Item A B B1 C D E F G Description vertical post base assembly Front Cap short hook clamp long hook c
PAGE 2
Assembly Instructions: Tools Required: Two 8” adjustable wrenches or equivalent, Phillips screwdriver. For ease of assembly, we suggest that you use your vehicle’s hitch. 1 Step 1: Assemble Receiver Tube to Base Assembly 1. Install your receiver tube H into the hitch. Unlock hitch pin K and insert it through hole in the hitch and the rack. Be sure that the pin passes through the welded loop on the end the bolt attached to the lever H7.
PAGE 3
Step 2: Install Wheel Holders: Rotate and remove L pins from holes A. Rotate wheel tubes to a horizontal position, then replace L pins into holes B as indicated. Fig. 2a Slide wheel Holders E and F onto wheel tubes as indicated. 2 Fig. 2b Fig. 2c After installing wheel holders, install the “stop” screws (item P) into the bottom of the wheel tubes as indicated in Figure 2c. Use Phillips screwdriver. Item P Step 3: Installation and operation of Clamp System Fig.
PAGE 4
Step 4: for installation of HR1475 2 bike add-on kit (sold separately) Step 4: Installing extension assembly for 4 bike capacity Note: Remove front square reflector cap B1. You will need a Phillips head screwdriver (screw located on bottom of tube. (Please put it someplace where you won’t lose it!) 3 Fig. 4a Slide extension assembly all the way into base assembly B per Fig. 4a. Insert the pin through the holes.
PAGE 5
Tilt –Down Feature: For easy access to the rear cargo door of your vehicle, the Sport Rider can be tilted down: First fold down vertical Post as described in “Fold-up feature”. Next refer to fig. 1a: Remove pins H5 then H6 from receiver tube bracket and gently lower the main beam down so it is resting on the welded stop. 4 Fig. 5c Fig. 6a Step 6: Installing bikes on the rack The bikes should be mounted from inside (1st bike) to the outer most bike (3rd or 4th bike). See Fig. 6a.
PAGE 6
Double check before driving off:      Knobs are tight on all four wheel trays and both frame hooks.