Home Theater System User Manual

ENGLISH

OPERATING THE TIMER

• Then it enters the on time setting mode and the

hour digit is flickering for several seconds.

• In the standby mode, you can set the timer, too.

• In case of setting the timer for the first time, press

this button briefly to enter the timer setting mode.

󰥒Notes:

• If the timer setting mode display disappears, start

again from the step 1.

• In the power saving mode, you cannot set the

timer.

• Then it enters the input setting mode and the input source

is flickering for several seconds.

󰥒Note :

• If the on time and the off time are the same, when the

ENTER button is pressed, the off time will not be set. In

this case, set the off time different from the on time.

• Then the minute digit is flickering for several seconds.

• Then it enters the off time setting mode and the hour digit is flickering for several seconds.

• Once the timer is set to on, it will operate at the preset time once or everyday.

󰥒Before setting the timer

• Make sure the clock has been set correctly. If not, when the TIMER button is pressed, "CLOCK ADJust" message is

displayed and it will enter the clock setting mode.

In this case, first set the clock performing "SETTING THE CLOCK" procedure on page 49.

󰥒Note :

• If the electricity fails or the AC input cord is unplugged, the current time and the timer setting will be cleared. Should this

happen, set the clock and the timer again.

1. Press the TIMER button for more than 2 seconds to enter the timer setting mode.

2. While flickering the hour digit, press the CURSOR UP/DOWN (▲/▼) buttons to set the hour for on time and

press the ENTER button.

3. While flickering the minute digit, press the CURSOR UP/DOWN (▲/▼) buttons to set the minute for on time

and press the ENTER button.

4. Repeat the above steps 2 and 3 to set the off time.

VR-652(A) 2008.3.6 5:32 PM 페이지 50